25
© 2009 by Thermoplan AG , Subject to change
User Manual CT / CTS / CTMcool
805.012_REV-1_EN
Display messages What?
Piston error
1. Reselect any beverage
2. If not OK => contact service
Overtime error
Coffee extraction time IS too slow, (grind adjustment may be too fine)•
1. Press Cleaning key
2. Repeat process
Water flow blocked•
1. Check
2. => contact service
NTC coffee
CPU does not receive signal from NTC sensor on coffee boiler•
1. => contact service
NTC Foamer
CPU does not receive signal from NTC sensor on Foamer heating•
1. => contact service
If for any reason the machine had to be turned off,
wait at least for 10 sec. before turning on again!
User display messages
To Next Page
Loading...
Need help?
General
