EasyManua.ls Logo

ThermoSpas Park Ave Diamond User Manual

ThermoSpas Park Ave Diamond
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ThermoSpas®
Designer Series Owners Manual
Safety, Maintenance and Technical Information

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the ThermoSpas Park Ave Diamond and is the answer not in the manual?

ThermoSpas Park Ave Diamond Specifications

General IconGeneral
BrandThermoSpas
ModelPark Ave Diamond
CategoryHot Tub
LanguageEnglish

Summary

Read and Follow These Important Instructions

Proper Use and Installation

Guidance on safely installing, operating, and maintaining your spa.

Choosing A Location

Guidelines for selecting an optimal indoor or outdoor location for your spa.

Programming Instructions

Standard Mode

Maintains set temperature. Heater activates as needed.

Economy Mode

Heats only during preset cycles. Saves energy.

Economy Mode Heating Cycles

Program specific heating cycles for economy mode operation.

O3 Ozone

Indicates activation of the optional ozonator system.

Automatic Functions

Freeze Protection

Activates pumps/blower to prevent freezing below 44°F.

Circulation Pump

Runs 24/7 for continuous filtration, may auto-off if temp exceeds set-point.

Basic Spa Maintenance

Scheduled Maintenance

Clean shell weekly, filters 1-3 weeks, drain/refill 3-4 months.

Changing/Cleaning Filters

Cleaning The Filter

Clean filter cartridges monthly or as needed to ensure optimum performance.

Drain and Refill

Drain and Refill Procedure

Procedure for draining and refilling the spa every 4 months, including line flushing.

Cleaning the Cover

Flushing Lines

Flush plumbing lines every 6-12 months to remove accumulated bacteria and scum.

Winterizing (Closing Your Spa)

Components

Circulation/Filtration Pump

Continuous filtration pump. Configuration varies by model.

Common Diagnostic Messages

ICE

Freeze protection activated: pumps/blower run below 44°F.

Common Reminder Messages

Troubleshooting - Water Chemistry

Cloudy Water

Troubleshoot cloudy water caused by dirty filters, high TDS, pH, or calcium.

Troubleshooting - Mechanical Systems

Pump(s) will not start

Diagnose issues like 'T' valve, priming, or frozen impeller.

Spa Pump(s) surging

Diagnose surging from air pull-through or low water level.

"FLO" Appears on Control Panel

Check pump status, water level, surging, and filter cleanliness.

No Water Pressure in Sections of the Spa

Diagnose issues from incorrect diversion, pump off, or closed jets.

dr/dry

Inadequate water in heater: check T-valves, prime pump, or contact service.

Spa Not Heating (Heat Icon On)

Troubleshoot heating issues: pump status, T-valves, mode, filters, water level, heater.

OHH (Overheat)

Spa shut down (110°F): check T-valve, add cool water, check filters.

Circulation Pump Not Working

Check if water temperature is 3° or more above set temperature.

Breaker keeps tripping or will not Reset

Troubleshoot wiring, controller, or heater issues.

Spa Leaks

Check unions, drain valve, barb fittings, or glue fittings. Contact service if needed.

Water Chemistry Maintenance

Test and Balance Alkalinity

Bi-weekly test and adjustment of alkalinity levels (80-120 ppm).

Test and Balance pH

Bi-weekly test and adjustment of pH levels (7.2-7.8).

F.A.Q.s

Floor Load Determination

Floor Load Determination

Guidelines for maximum spans for decking floor joints based on wood grade and load.

Electrical Requirements Chart

Electrical Requirements Chart

Details voltage, breaker size, wires, and gauge for various spa models.

Spa Measurements Chart

Spa Measurements Chart

Provides dimensions, weight, and pad size for different spa models.

Water Capacity Chart

Water Capacity Chart

Lists approximate average water fill volume in gallons and liters for spa models.

Related product manuals