Every DMX device operates with a certain vendor specic number of channels through which
the incoming control signals are converted into movements, brightness or colour changes,
etc.. Since all receivers in a DMX chain always receive all signals, a starting address must be
assigned to each DMX device. Starting from this address (a value between 1 and 512), the
incoming signals are then interpreted by the receiver and implemented in accordance with
the function mode set on the receiver (device-internal channel assignment).
Within a DMX chain, one start address can easily be assigned multiply. The corresponding
receivers then operate synchronously (same movements, same brightness, same colour, etc.).
Signal conversion
DMX basics and addressing
18
Rainbow Rider DMX
DMX controller
To Next Page
Loading...
