This menu is used to lower or raise the level of the input signal in a range of –12 dB to +12 dB.
Press [A] or [B] to activate the edit mode for channel A or B and to open the ‘INPUT A/B’ menu.
Use [PM2] or [PM3] to adjust the level of the input signal as required. Confirm the new setting
with [ENTER].
Pressing [ESC] exits the menu without applying changes.
This menu is used to customise the signal delay in a range of 000.0000 ms to 848.9984 ms.
Press [A] or [B] to open the ‘INPUT A/B’ menu.
Press [ENTER] and use [PM2] to roughly adjust the signal delay in increments of 1 ms , or use
[PM3] to finely adjust it in increments of 20.8 ms. Confirm the new setting with [ENTER].
Pressing [ESC] exits the menu without applying changes.
"Gain"
"Delay"
Operating
digital speaker management system
36
To Next Page
Loading...
