This menu is used to define the parameters that are visualised by the LEDs of the output chan‐
nels. Press [1], [2], [3], [4], [5] and/or [6], to activate the edit mode for channel 1, 2, 3, 4, 5 and/or
6.
Press [ENTER]and use [NAV/PM1] or [PM2] to switch between the options ‘Limiter Act’ (limiter
response) and ‘Level’ (signal level).
Pressing [ESC] exits the menu without applying changes.
This menu is used to assign an individual name to each output channel. Press [1], [2], [3], [4], [5]
and/or [6], to activate the edit mode for channel 1, 2, 3, 4, 5 and/or 6.
Use [PM2] or [PM3] to enter a desired name with a maximum of six characters. The cursor can
be placed in any position with [NAV/PM1], for example to overwrite a character that has been
entered incorrectly.
Pressing [ESC] exits the menu without applying changes.
This menu is used to adjust the assignment between the input and output channels. Press [1],
[2], [3], [4], [5] and/or [6], to activate the edit mode for channel 1, 2, 3, 4, 5 and/or 6.
Press [ENTER] and assign the required input to the active output with [PM2] or [PM3].
Pressing [ESC] exits the menu without applying changes.
"Vu Meter"
"Name"
"Source"
Operating
DSP 26
43
To Next Page
Loading...
