Thomas 300 SUPER CUT - Page 19

24 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

18

SUPER CUTSUPER CUT

SUPER CUTSUPER CUT

SUPER CUT

V 400 / 50 Hz

CIRCUIT DIAGRAM

THREE-PHASES

Table of Contents

Contents3
Ordering Spare Parts3
- Table of Contents3
Guarantee3
Machine Certification and Identification Marking4
CHAPTER 1 Reference to Accident-Prevention Regulations5
- Advice for the Operator5
- Location of Shields against Accidental Contact with the Tool5
- Electrical Equipment According to European5
- Standard "CENELEC en 60 204-15
- Emergencies According to European Standard "CENELEC en 60 204-1" (1992)5
CHAPTER 2 Recommendations and Advice for Use5
- Recommendations and Advice for Using the Machine5
CHAPTER 3 Technical Characteristics6
- Table of Cutting Capacity and Technical Details6
Chapter 4 Machine Dimensions Transport Installation Dismantling7
- Machine Dimensions7
- Transport and Handling of the Machine7
- Minimum Requirements for the Premises Housing the Machine7
- Anchoring the Machine7
- Instructions for Electrical Connection8
- Instructions for Assembly of the Loose Parts and Accessories8
- Disactivating the Machine8
- Dismantling8
CHAPTER 5 Machine Functional Parts8
- Operating Head8
- Vice8
- Bed9
CHAPTER 6 Description of the Operating Cycle9
- Starting up and Cutting Cycle9
Chapter 79
Regulating the Machine9
- Disk Head9
- Vice9
- Cutting Angle Adjustment10
- Changing the Disk10
- Changing the Lubricating Coolant Pump10
CHAPTER 8 Routine and Special Maintenance10
- Daily Maintenance10
- Weekly Maintenance10
- Monthly Maintenance10
- Six-Monthly Maintenance10
- Oils for Lubricating Coolant10
- Oil Disposal11
- Special Maintenance11
CHAPTER 9 Material Classification and Choice of Tool11
- Definition of Materials11
- Choosing the Disk11
- Teeth Pitch12
- Cutting and Advance Speed12
- Running in the Disk12
- Disk Structure12
- Type of Disks12
CHAPTER 10 Machine Components14
- List of Spare Parts14
Chapter 1118
Wiring Diagrams18
CHAPTER 12 Troubleshooting20
- Blade and Cutting Diagnosis20
- Electrical Components Diagnosis22
Chapter 1322
Noise Tests22
CHAPTER 14 Optional23
- Pneumatic Vice23
- Connection to the Pneumatic System23
Plates and Labels23
Notes24

Related product manuals

Thomas 315 SUPER CUT

Thomas 275 SUPER CUT