Wet vacuuming procedure
Only use the vacuum to remove water-based fluids.
The procedure is the same as for dry vacuuming,
except for the following:
Open the AQUA-Pure filter box.
To do this, release the unlocking tab on the aqua filter lid.
Swivel open the aqua filter lid and take it off.
Do not fill the AQUA-Pure filter box with water.
If there is water in the aqua filter, empty it.
Close the lid of the AQUA-Pure filter box.
To do this, place the aqua filter lid in the two holders on the waste
water tank and gently push the lid down until you hear the unlocking
tab latch into place.
For wet vacuuming, the auxiliary air slide on the handle of
the suction hose must always be closed.
Perform wet vacuum cleaning.
Only use the vacuum to remove water-based fluids. Afterwards,
clean the AQUA-Pure filter box as described below.
Wet vacuuming – removing liquids
Lower the wet vacuuming insert into the waste water tank.
For wet vacuuming, the wet vacuuming insert must be in
the waste water tank.
»click«
»click«
»click«
12 THOMAS
To Next Page
Loading...
