Thomas perfect air - Troubleshooting; General Troubleshooting; Dry Vacuuming Issues; Wet Vacuuming Issues

GB
Troubleshooting
GB
Problems / malfunctions Cause / remedy
General (all functions)
The appliance will not start • Are the power cord, plug and socket intact?
• Before checking, unplug the power cord; have all repairs carried
out by authorised specialists
• Is the appliance switched on? ➔ Check
Vacuum cleaning (dry vacuuming)
Dust comes out of the appliance
during vacuuming
• Is the aqua filter system fitted as described in the user manual?
• Is there enough water in the waste water tank? ➔ Check
Suction power gradually decreases • Is the special hygiene filter clogged? ➔ Clean the special
hygiene filter
• Are the nozzles, suction pipe or hose blocked by coarse dirt?
➔ Stretch the hose during operation to loosen the blockage;
remove the blockage
• Is the housing cover properly shut? ➔ Check
Suction power is too low • Is the ejector in the suction port clogged? ➔ Disassemble and
clean or rinse out with water
• Is the special hygiene filter clogged? ➔ Clean the special
hygiene filter
• Are the nozzles, suction pipe or hose blocked by coarse dirt?
➔ Disassemble and clean
• Is the electronic suction power control set to MIN?
➔ Set the suction power to MAX
• Is the mechanical suction power control on the handle open?
➔ Close the sliding button on the handle
Numerous water droplets on
the inside of the housing cover
• The AQUA-Pure filter box is probably too full of dust
➔ Clean the AQUA-Pure filter box, change the water
Problems / malfunctions Cause / remedy
Wet vacuuming
The appliance switches off
during operation
• Is the waste water tank full (float switch triggered)?
➔ Empty it
• Have you tilted or suddenly turned the appliance (float switch
triggered)? ➔ Make sure the appliance is level and switch it
on again.
Water comes out of the exhaust
openings
• Is the float in the waste water tank dirty and stuck, which
means it can no longer respond when the tank is full?
➔ Clean the float and the tank
An excessive pool of water collects
in the suction chamber (a few drops
are considered normal)
• Are the gaskets and seal faces heavily soiled?
➔ Clean them
• Did you forget to put in the wet vacuuming insert? ➔ Check
18 THOMAS
THOMAS