Cleaning
Before cleaning, always switch off the appliance by holding the
start button depressed and then unplug it from the socket.
Do not use scouring agents or solvents for cleaning.
After cleaning, allow the appliance and accessories to
completely dry.
Cleaning the AQUA-Pure filter box when lightly soiled
When dry vacuuming, change the water (1 litre) in the AQUA-Pure
lter box at least every 30 minutes, because it will have evaporated
or become dirty by then. Quick cleaning procedure:
a) Leave the waste water in the AQUA-Pure filter box.
b) Fill it up with clean water through the port. This cleans the inside of
the port at the same time.
c) Tilt the AQUA-Pure filter box so that the water inside it comes into
contact with all dirty surfaces.
d) Place the AQUA-Pure filter box on a level surface. Then open the lid of
the AQUA-Pure filter box.
e) Pour the dirty water out through the outlet.
f) Rinse it once again with clean water.
g) Close the lid of the AQUA-Pure filter box.
This quick cleaning procedure for light soiling does not mean there
is no need to clean the AQUA-Pure filter box at the end of use.
If you have not yet finished vacuuming, remember to fill the
emptied AQUA-Pure filter box again with 1 litre of clean water
before resuming dry vacuuming.
Cleaning
Cleaning the AQUA-Pure filter box when heavily soiled
Carry out steps a) to e) under “Cleaning the AQUA-Pure filter box
when lightly soiled”.
Open the AQUA-Pure filter box.
To do this, release the unlocking tab on the aqua filter lid.
Swivel open the aqua filter lid and take it off.
Take out the two foam filters.
To do this, remove the second stage of the unlocking tab. Fold apart
the two sections of the aqua filter lid. Take out the two foam filters.
For wet vacuuming only: If the wet vacuuming insert is installed,
lift it out of the waste water tank.
13
To Next Page
Loading...
