Cleaning
If heavily soiled, you can remove the ejector for cleaning by turning
the port gasket.
Rinse the ejector with warm water.
If the suction filter was removed, place it back in the waste
water tank.
For wet vacuuming only: If the wet vacuuming insert was removed,
lower it back into the waste water tank. Make sure that the float
switch can move freely.
Insert the two foam filters. Close the two parts of the aqua filter
lid until you see and hear them latch into place.
Close the AQUA-Pure filter box.
To do this, place the aqua filter lid in the two holders on the waste
water tank and gently push the aqua filter down until you hear
the unlocking tab latch into place.
Clean all components of the aqua filter with clean,
if necessary warm, water.
Allow all components to completely dry.
If there is still dirt in the waste water tank of the AQUA-Pure filter
box, rinse it thoroughly under running water and pour the waste
water out through the outlet.
If the suction filter is heavily soiled, remove it from the waste water
tank and rinse it under running water.
14 THOMAS
To Next Page
Loading...
