EN
7
CD Player
Loading and Playing CDs
1. Push lightly to open the CD door. Load a CD
(with labeled side facing up) into the CD
compartment. Then, close the door by pushing
it down lightly.
2. Press CD to select CD mode and the power will
be turned on automatically.
3. Press PLAY/PAUSE to play and pause CD
playback.
You may:
• skip to other tracks by pressing SKIP
BACKWARD or SKIP FORWARD .
Press and hold SKIP BACKWARD or
SKIP FORWARD to search.
• press REPEAT on the remote control once to
repeat all tracks. REPEAT is shown in the
display simultaneously. Press again to play a
particular track repeatedly, at the same time,
REPEAT 1 is displayed. Press a third time to
de-select the function.
• Press to listen to the tracks randomly.
4. Press STOP to stop playback.
Tip: Tip:
Tip: Tip:
Tip: If the CD compartment is not loaded with
a CD or the CD is unreadable, the message
“
NO DISCNO DISC
NO DISCNO DISC
NO DISC” will be shown.
Note: Be sure to remove all discs from the
disc compartment before moving or
transporting the unit!
Setting Intro Play
Intro Play lets you enjoy the CD tracks for 10
seconds. When the last track has played for 10
seconds, the Intro Play stops.
1. Follow step 1 and 2 of “Loading and Playing
CDs” above.
2. Press INTRO on the remote control and the
INTRO icon will be shown.
3. Press PLAY/PAUSE to start playback from
the first track. Press SKIP BACKWARD
or SKIP FORWARD to select a particular
track.
4. Press INTRO again to exit intro play.
Programming
1. Select CD mode by pressing CD.
2. Press PROG•SET•CLEAR after the CD has been
loaded into the system. The message “0 PR 1”
will be shown on the display and PROG.
flashes.
3. Press SKIP BACKWARD or SKIP
FORWARD to select a track to be stored
into memory location 1.
4. Press PROG•SET•CLEAR to confirm your
selection and store that track into memory.
Repeat step 3 and this step to store additional
tracks. A maximum of 20 tracks can be stored
into memory.
5. Press PLAY/PAUSE to run the preset
program. When the unit is playing the
program, “PROG” icon will be displayed.
6. Press PROG•SET•CLEAR in CD programming
mode and press and hold STOP to clear the
stored program.
Notes to CD-R/RW
This unit is compatible with CD-RW/ CD-R discs
for playback.
• Do not affix any type of labels to either side
(recordable or labeled side) of a CD-R/RW disc
as this may result in the unit malfunctioning.
• To avoid damages to the CD-R/RW disc, do not
open the disc compartment door while the
disc is being read.
• Do not load an unrecorded CD-R/RW disc into
the unit. This may take a longer time to read
the disc.
• Playback capability for CD-RW discs may
vary due to variations in the quality of
the CD-RW disc and the recorder used to
create the disc.
ON•ECO
DIGITAL PLL SYNTHESIZED TUNER
MULTI FUNCTION LCD DISPLAY
TUNING
IR SENSOR
TIMER
V
O
L
U
M
E
C
O
N
T
R
O
L
CD
Untitled-4 4/10/03, 1:57 PM12
To Next Page
Loading...
