EasyManua.ls Logo

THOMSON DS120CD - Page 16

THOMSON DS120CD
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- EN 17 -
Getting started
Take the device out of the box.
Remove all the packaging from the product.
Place the packaging inside the box or dispose of it safely in compliance with the wa󰘵e
sorting in󰘵ructions shown on the outside.
Safety warning and notice
You mu󰘵 read and under󰘵and all the in󰘵ructions before using this device. The warranty will
not apply if damage is caused by failure to follow the in󰘵ructions.
1. Never remove the device casing.
2. Never place this device on top of other electrical equipment.
3. Protect the power cable from being 󰘵epped on or pinched, particularly at
the plugs, sockets, and the point where it exits the device. Make sure that
the power rating corresponds to the voltage shown on the rating plate at the
rear of the device. Always pull the plug from the socket when disconnecting
from the mains. Never pull on the cable. Ensure you have completed all the
other connections before connecting the mains plug.
4. Only use attachments/accessories that are recommended by the
manufacturer.
5. Entru󰘵 all device repairs to quali󰘰ed repairers. Repair is needed when the
device has been damaged in any fashion, and in particular:
- if the power cable is damaged;
- in the event of a liquid spill or objects being inserted into the device;
- if the device is exposed to rain or dampness;
- if the device does not operate normally;
- or if the device has been dropped or impacted.
6. The series panel is located on the bottom of the device.
7. Never block the air vents.
8. Make sure you have enough space for ventilation. Place the product on a 󰘵able surface.
9. This device mu󰘵 be used in a moderate climate, away from direct sunlight, naked 󰘱ames
or sources of heat, heaters, cookers or any other devices (including ampli󰘰ers) that
generate heat. Do not in󰘵all near a heat source.
10. The batteries (battery pack or inserted batteries) mu󰘵 not be exposed to excessive heat,
such as sunshine, 󰘰re, etc.
Getting started 17
Safety warning and notice 17
Contents of the box 19
Description of parts 20
Before starting 22
Operation 22
Use 23
Warning about batteries 25
Environmental protection 26
Additional information 27
Declaration of conformity 27
Warranty 27

Related product manuals