THOMSON DS120CD - Media Playback Modes; Disc and Audio File Playback; Radio Tuning and Presets

- EN 23 -
2. Make sure that you have set the clock correctly.
3. Press ALARM button in shutdown 󰘵ate, the display will 󰘱ash ON to select setting alarm
4. Press the ALARM con󰘰rm, the time display will blink.
5. Press or button repeatedly to set hour. Press ALARM to con󰘰rm.
6. Press or to set minute.
7. Press ALARM to con󰘰rm, and then press or to select CD/FM/USB/SD 󰘵atus.
Press ALARM to con󰘰rm.
8. The volume would turn up from 0 to 20 gradually.
9. Press ALARM button in shutdown 󰘵ate, the display will 󰘱ash ON to select setting alarm,
and the display will blink.
10. Press the or to select OFF to cancel alarm.
Use
Carefully deploy the telescopic aerial.
Press the POWER button to turn on the device, which will automatically switch to CD
mode.
Play a disc
1. Press SOURCE repeatedly to select DISC source.
2. Put on a disc with the printed side facing upward.
3. Play 󰘵arts automatically, if not, Press .
4. Press the VOL+/VOL– to adju󰘵 the volume.
Pause / resume play
1. During play, press to pause/resume play.
2. During play, long press or button to fa󰘵 forward/fa󰘵 rewind.
Skip to a track
For CD:
1. Press or to select another track.
2. Press the VOL+/VOL – to adju󰘵 the volume.
For MP3 disc and USB/SD
1. Press or to select a track or a 󰘰le.
2. Press the VOL+/VOL – to adju󰘵 the volume.
Search within a track
1. During play, press and hold or .
2. Release to resume normal play.
Li󰄋ening to radio
You can program a maximum of 20 preset radio 󰘵ations (FM).
1. Press the SOURCE button to select RADIO mode. The unit will be in FM radio mode.
2. Press or to search radio 󰘵ation.
3. Select the desired radio 󰘵ation by pressing the or button.
4. Once you 󰘰nd a 󰘵ation you want to save, press the MEM button on the remote control,
”P01” will be shown on the display, press MEM+/MEM- until the desired memory position