16
Use
Programming a recording
Your video recorder has eight programming memories. Thus, you will be able to
programme eight recordings over a 1-year period.
Load a tape and position it to the desired section using the REV., FWD, STOP and PLAY
keys.
Programming using a PlusCode
®
number
Each televised broadcast has its own PlusCode number guide which can be found in
your TV magazine. To programme the recording of a broadcast, all that is required is for
you to enter this number in the
VIDEO Plus+
menu; it contains the date, start and end
time and the number of the channel broadcasting the programme.
1 Call up the VIDEO Plus+ menu using the PROG. key.
2 Enter the PlusCode number of the programme using the number keys.
3 Confirm using OK.
The TIMER menu comes up.
You may complete your programming by choosing daily or weekly repetition,
double length or VPS- or PDC-signal triggered recording.
When programming for the first time, the cursor positions itself on Prog. number;
confirm or enter the desired programme number.
4 Press the OK key.
5 Leave the menu using the EXIT key.
6 Put the video recorder in standby mode using the B key.
The symbol on the display of the VCR confirms that your programming was
successful.
VIDEO Plus+ and PlusCode are registered trademarks of Gemstar Development
Corporation.
The VIDEO Plus+ system is manufactured under licence from Gemstar Development
Corporation.
Storage of the programme numbers with the VIDEO
Plus+ feature
The video recorder automatically stores the correspondance between channel numbers
and PlusCode numbers so that you do not have to re-enter for each programming the
channel number corresponding to the PlusCode programming number .
This is to say that the first time you programme a recording on a channel using the
VIDEO Plus+ feature, the video recorder will prompt you to confirm or enter the channel
number. When programming your next VIDEO Plus+ recording, the video recorder will
automatically identify the channel concerned.
VIDEO PLUS+ system and satellite demodulator
If you use the PlusCode numbers to record a programme broadcast by satellite, the
VIDEO Plus+ programmer can ask you to confirm the channel number (Pr99 / AV1 /
AV2).
VCR
To Next Page
Loading...
