- EN 5 -
Preparing the remote control
• Use alkaline battery. (not supplied)
• Install the battery so that the poles (+ and -) align with those in the remote control.
• Close the battery compartment.
Note: If you are not going to use the remote control for a long time, remove the battery. Batteries
contain chemical substances, so they should be disposed of properly.
ATTENTION: Danger of explosion if batteries are not inserted correctly
Preparing the media
Disc
1. Press [CD] (main unit: ) to open the disc tray.
2. Put in a disc with the label facing up
3. Press again to close the disc tray, the “READING” shown.
USB
1. Reduce the volume and connect the USB device to the USB port
2. Hold the main unit when connecting or disconnecting the USB device
3. Press [USB] or press repeatedly [Source] on main unit to select “USB”, the “READING” shown.
Bluetooth
®
You can connect and play an audio device wirelessly through Bluetooth
®
Preparation
• Switch on the Bluetooth
®
feature of device and put the device near the system.
• Read the operation instructions of the device for details.
Pairing a device
1. Press ,the “PAIRING” is shown,
2. Select “MIC120BT (MIC122BT/MIC125BT)” from the Bluetooth menu of the device.
If prompted for a passkey, input “0000”
The device connects with this system automatically after pairing is complete.
The name of the connected device is shown for a few seconds.
3. If this system is connected to a Bluetooth device, press and hold the to disconnect it, until the
[PAIRING] is shown.
4. Start playback on the device.
To Next Page
Loading...
