THOMSON MIC122DABBT - Clock and Timers

- EN 6 -
Clock and timers
Setting the clock
After the unit is plugged into a mains supply or following a mains power failure, the display will show
“0:00” on the LCD display. The unit should be in standby mode to set the current clock.
1. Press the [TIME] button. The digits for the display will blink.
2. Press the / button repeatedly until the correct hour is set. Press [ENTER] to conrm the hour
setting.
3. The minute digits on the display will blink.
4. Press the / button repeatedly until the correct minute is set. Press [ENTER] to conrm the
minute setting.
Setting the alarm
This unit can be used as an alarm clock. The Bluetooth device, USB and FM are activated to play at
a preset time.
1. Press to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press the [ALARM] button in shutdown mode. The display will ash ON to select alarm setting,
and the display will blink.
4. Press [ENTER] to conrm. The time display will blink.
5. Press the / button repeatedly to set the hour. Press [ENTER] to conrm.
6. Press / to set the minutes.
7. Press [ENTER] to conrm, and then press / to select CD/DAB/FM/USB status. Press [ENTER]
to conrm.
8. The volume turns up from 0 to 20 gradually.
9. Press the [ALARM] button in shutdown mode. The display will ash ON to select the alarm setting,
and the display will blink.
10. Press / to select OFF to cancel the alarm.
Snooze
1. Press to set the alarm; it re-sounds after 9 minutes.
Sleep timer
1. Press the [SLEEP] button. The display will blink. Press the button until the display shows the
minute you want to set. You can set 90/60/45/30/15 minutes.
2. It blinks three times to conrm, and then returns to the previous interface. If you want to cancel the
sleep mode, press OFF. After blinking three times, sleep mode will cancel.
Playing the media
Disc
Play a disc
1. Press [SOURCE] repeatedly to select DISC
source.
2. Insert a disc with the printed side facing upward.
3. Play starts automatically, if not, press .
4. Press the [VOL+/VOL-] to adjust the volume.
Pause / resume play
• During play, press to pause/resume play.
• During play, long press the / button to fast forward/rewind.
Skip to a track
For CD:
1. Press / to select another track.
2. Press the [VOL+/VOL-] to adjust the volume.