- EN 8 -
3. Press or to go to the desired channel. The graph will indicate the signal strength.
4. Press [MENU] or to exit scan.
5. If no stations are found, please ensure the aerial is extended and test the reception by doing
another auto scan in a different location.
DRC (Dynamic range control)
Dynamic Range Control (also known as DRC) is a technology used to help make quieter sounds
easier to hear in a noisy environment.
1. Under DAB mode, press or to select “DRC”. Press the [ENTER] key and “*” will be
displayed on the top right.
2. Press MENU to conrm the setting. The display will return to normal.
DRC OFF - DRC is switched off, Broadcast DRC will be ignored.
DRC LOW - DRC level is set to 1/2 that sent by broadcaster.
DRC HIGH - DRC level is used as sent by broadcaster.
Prune (To remove stations which are listed but unavailable)
Under DAB mode, press or to show the submenu” Prune”. Press the [ENTER] button to
access the Prune option.
System (DAB)
Under DAB mode, press or show the ”SYSTEM” submenu. Press the ENTER button to
enter the system setting.
1. Language
Press [ENTER] to set the language. The source language is English and the selected language
will have ”*” displayed on the top right.
It’s available in a choice of “Deutsch”, ”Italiano”,”Français”.
2. Factory Reset
Press [ENTER] for factory reset. If you wish to perform the reset operation, push or
until “YES” is highlighted on the display and press [ENTER]. A full reset of your radio will be
performed. All presets and station lists will be erased.
3. SW Version
Press [ENTER] to view the DAB software version. Press [Menu] or . The display will return
to normal.
*If no buttons are pressed after 30 seconds, the display will return to normal.
To Next Page
Loading...
