EasyManua.ls Logo

THOMSON MIC200IDABBT - Specifications and Warnings; Technical Specifications; Hearing Safety Warning; Disc Handling and Care

THOMSON MIC200IDABBT
220 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- EN 14 -
Note the following information: Only use the power supplies listed below.
Specication:
Power: AC100-240V~ 50/60Hz 0.3A
Remote control power source: 1 x CR2025 3V battery (included)
Frequency ranges: FM 88.8 – 108MHz
DAB/DAB+ 174 - 239MHz
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth speaker
as close as possible to this device to avoid connection getting disturbed.
WARNING! Risk of hearing impairment
Set a low volume on the playback device before connecting the headphones to the
sound source.
Avoid excessive volume, particularly over extended periods or frequent use. Excessive
volume can result in permanent hearing impairment.
About the disks
Handling
Do not touch the underside of disks.
Hold disks by the edges to avoid leaving ngerprints on the surface.
Any dust, ngerprints or scratches may cause a malfunction.
Never afx a label or sticky tape to the disk.
Storage
Put disks back in their case after use.
Never expose disks to direct sunlight or heat sources. Never leave disks
inside a car parked in full sunlight.
Cleaning
Use a clean, soft, lint-free cloth to clean the disk, working from the centre
outwards in a straight line. Do not use solvents such as petrol, thinners,
commercially available cleaners or antistatic sprays for vinyl disks.

Table of Contents

Related product manuals