5
Operating the Clock
EN
Waking by Selected Source
Programme
You may be woken up by radio
or buzzer .
1. Select a radio station. (refer to “Tuning
the Stations”)
2. Set wake time (see above direction).
3. Press the ALARM MODE button to se-
lect either waking up by radio or
buzzer. A red indicator is up next to
the selected setting.
4. Adjust the volume level by turning VOL-
UME.
Note: When you turn off the buzzer
or the radio by pressing ON/
OFF, the buzzer or the radio will
turn on at the same time tomorrow.
Sleep Mode
In sleep mode, the radio will turn off au-
tomatically. Simply:
1. Press SLEEP then the time display will
exhibit 0:59 and the radio will turn on.
2. While holding SLEEP, press REV or FWD
to set the sleep time. The time range is
from 1 minute to 2 hours.
3. Release SLEEP and the current time will
be shown again. The radio is turned
on and you may select the station as
usual. The radio will turn off when the
preset time elapses. If you decide to
turn off the radio sooner, press SNOOZE
or ON/OFF.
4. When SLEEP is activated again, the
sleep time will be the same as the one
you have set before.
5. Press SLEEP to read the remaining sleep
time.
Nap Mode
This function wakes you up after a short
period of time. Simply:
1. Press NAP and release. The NAP indi-
cator will flash. During this time pe-
riod, adjust NAP time by pressing REV
or FWD. The range is from 10 minutes
to 2 hours.
2. The clock will be shown after 5 seconds
if no buttons are pressed. The NAP
indicator will lit up.
3. Press NAP once to show time left.
RR60 EN 9/10/02, 5:28 PM6
To Next Page
Loading...
