THOMSON RT225DAB - Headphone Socket; Cleaning and Maintenance

- EN 7 -
NOTE:
• If there is no DAB+ reception at any time, change the position of the unit or adjust the antenna. Press
and hold the “SCAN / MODE” button for approx. 3 seconds to start a new search.
Favourite Station Presets
Press one of the direct selection buttons(hot keys) (1 - 3) to play the Preset station 1, 2 or 3.
DAB Menu
Press and hold “INFO / MENU” button to select the DAB radio menu. Press “SCAN+” or “SCAN-”
buttons to chose the following DAB menus and conrm with “ENTER / CLOCK” button:
- Full scan
The radio will automatically perform a full scan of DAB+ stations.
- Manual tune
Select a frequency with “SCAN+” or “SCAN-” button. Press “ENTER / CLOCK” button to conrm.
- DRC
Dynamic Range Control removes or adds the degree of adaptation, required for the differences
in dynamic range between stations.
Select an options with “SCAN+” or “SCAN-” button. Press “ENTER / CLOCK” button to conrm.
Following options are available on the display:
• DRC high: DRC turned on; default setting recommended for noisy environments.
• DRC low: DRC is set to half the normal level.
• DRC off: DRC is turned off.
- Prune
It may be that you can no longer receive some stations after a station scan or change of location. With
this function you can delete these stations from the reception list. Select “YES” and conrm with the
“ENTER / CLOCK” button.
- System
• Time
• Language
• Factory Reset
• SW version
Headphone socket
To listen to music privately, use headphones with a 3.5 stereo jack plug and connect to the headphones
socket on the back of the system. The speakers will then be muted.
Cleaning and Maintenance
WARNING:
Do not immerse the device in water.
• Always remove the mains plug before cleaning the machine.
• Any marks on the surface can be wiped off with a slightly damp cloth without any additives.