THOMSON silence - Page 43

1 4
Adjusting the salt consumption
1. Open the door and switch on the dishwasher.
2. Enter the status of salt consumption by holding down P until the value “H3” (factory
setting) appears on the display.
3. While the value shows on the display, repeatedly press P to adjust the setting from H1
to H6 to suit the water hardness.
4. Press to confirm the setting.
WATER HARDNESS
Display
Salt consumption
(gram/cycle)
°dH
°fH
°Clarke
mmol/l
0~5
0~9
0~6
0~0.94
H1
0
6~11
10~20
7~14
1.0~2.0
H2
9
12~17
21~30
15~21
2.1~3.0
H3
12
18~22
31~40
22~28
3.1~4.0
H4
20
23~34
41~60
29~42
4.1~6.0
H5
30
35~55
61~98
43~69
6.1~9.8
H6
60
NOTE:
1 °dH=1.25 ºClarke=1.78 ºfH=0.178mmol/l
°dH: German degree
°fH: French degree
°Clarke: British degree
Filling with salt
Unscrew the cap from the salt container by turning it anticlockwise.
Place the supplied funnel so the end fits into the opening of the salt container. Load
about 1.5kg of salt into the salt container.
Screw the cap back clockwise.
NOTE: The salt container must only be refilled when the refill salt indicator light
illuminates. Depending on how fully the salt dissolves, the refill salt indicator light
may still be on even though the salt container is filled.
Downloaded from www.vandenborre.be