19. Press OK softkey
20. Wait for ST2022 to reboot
21. The new IP address is set
22. Check that the IP address is set properly
Using DHCP
1. Press menu key.
2. Choose Admin with softkeys.
3. The phone will prompt Input Password:
Make sure you have selected the right entry mode with the A>a>1
softkey.
4. Enter the admin password using the Dialing pad (default value is
784515) and choose OK with softkeys.
Select Networking with Navigator keys and choose Select with
softkeys
5. The actual mode must now be highlighted. It can be DHCP, Fixed-IP or
PPPoE. Choose Edit with softkeys
6. Choose DHCP using the Navigator keys and choose Save with
softkeys
7. Press the Back softkey to return to previous menu.
8. Press the Back softkey once again to return phone idle mode.
9. Press menu key.
10. Choose Option with softkeys.
11. Use the Navigator keys to scroll down the menu to Reboot
12. Press Select softkey
13. The ST2022 displays Reboot?
14. Press OK softkey
15. Wait for ST2022 to reboot
16. The new IP address is set
17. Check that the IP address is set properly
To Next Page
Loading...
