THOMSON VPH7090 - NEW CHANNEL SETUP; Manual Channel Setup

EN
18
NEW CHANNEL
Press menu key to call up the SUMMARY menu.
With V or W, set the cursor on Installation and press
OK .
The option Manual set up is pre-selected. Press
OK .
You are now proposed a list of countries. With V or W, select the country where
you live or the country the channels of which you wish to receive, when residing in a
border region. Validate your choice with the
OK key.
The menu MANUAL SET UP comes up
The option Standard is pre-selected. Press C or B to select the TV standard.
With W, select the line Reception and choose aerial or cable with C or B (Cable for
cable TV channels, aerial for the channels received via your roof aerial).
Press W to select the line Auto search.
ST
ART CHANNEL SET-UP
Start channel set-up with C or B (the menu lay-out then becomes simpler to make
the identification of the channels easier for you). When a channel is found, the
pictures appear.
When the picture is good, set the cursor on channel name (W).
When the picture is poor, use the fine-tuning feature (W , C or B then W).
If the channel name is wrong or was not transmitted, scroll the channel names and
select a name from the list with C or B , otherwise continue with the next step.
If the channel is scrambled, set the cursor on Decoder (W) and tick the box by
pressing the
OK key, otherwise continue with the next step.
Set the cursor to Store on Pr and assign a number to the channel with key C or B.
To resume channel search, set the cursor with key V on Auto search and start again
with 3, ST
ART CHANNEL SET-UP.
1
2
3
4
5
6
SET UP
I-T7089PE-GB/BEI/906 20/07/99 18:14 Page 18