THOMSON WHP 265 - User Manual

1
Precautions
•
Safety - This device is designed for domestic use and should not be used for industrial
purposes. It must be installed and used in accordance with the instructions contained in
this notice.The prior reading of these instructions will make the installation much easier.
Follow the instructions carefully and carry them out in their correct order. Keep these
instructions for later reference.This devices is delivered with batteries. Before charging,
study the instructions of this manual. Disconnect the supply before making or breaking
connections to the batteries.
•
We recommend you disconnect the unit from the mains power supply during storms. If
you observe smoke or detect a suspicious smell, immediately disconnect the device from
the mains supply. For this reason you are advised to leave easy access to the mains plug.
Never open the unit yourself – you may be electrocuted.We recommend you disconnect
the unit from the mains power supply if you will be absent for a long period.
•
Ventilation, Heat, Humidity - Protect the unit from dust, humidity and sources of
excessive heat (such as a fireplace or radiator).The appliance should not be in contact
with liquids or exposed to the risk of dripping or splashing.Therefore be careful not to
place any object containing a liquid (vase, glass, bottle,...) on or near your appliance. Do
not expose it to direct sunlight. Its maximum ambient operating temperature is 35° C.
The ventilation should not be impeded by covering the ventilation openings or the device
itself with items such as, newspapers, tablecloths, curtains, etc. No naked flame sourced,
such as lighted candles should be placed on, or close to, the device.
•
Your unit is designed for use in a dry environment. If for exceptional reasons you must
utilise it out of doors (balcony, veranda, etc.) take care to protect it from dampness
(dew, rain, splashes).
The maximum ambient humidity that the device supports is 85%. If your unit is cold
and you wish to use it in a warm room, wait until any condensation on the unit
evaporates by itself before you switch it on.
•
You must only clean your unit using a soft cloth soaked in a neutral detergent.You may
damage your unit if you use solvent or an alcohol-based product. If you are unsure, test
the cleaning product on the underside of the unit.
THOMSON declines all liability for any use that does not comply with this instruction
notice.
en
WHP 265 - 16 langues 14/05/03 12:08 Page 1

Summary

Precautions

Safety

General safety guidelines for domestic use and installation.

Ventilation, Heat, Humidity

Guidelines on environmental conditions for device operation and placement.

Cleaning

Instructions for cleaning the unit using a soft cloth and neutral detergent.

Connections

Connection Diagram

Diagram illustrating how to connect the transmitter and headphones to audio sources.

Placing in operation

About your WHP 265

Overview of the WHP 265 system, including headset and transmitter.

Installing the transmitter

Steps for positioning and connecting the infra-red transmitter to the audio source.

Putting the headset in service

Instructions for installing batteries and connecting the headset to the transmitter.

Charging the rechargeable batteries

Details on charging rechargeable batteries, including initial time and memory effect.

Use

Operation

Step-by-step guide on operating the transmitter and headphones for listening.

Signal lamps

Explanation of LED indicators for headset charging and operation status.

Features

Technical specifications for transmitter and headset, including frequency range and range.

THOMSON WHP 265 Specifications

General

Type	Over-ear
Connectivity	Wireless
Wireless Technology	Bluetooth
Bluetooth	5.0
Driver Size	40 mm
Frequency Response	20 Hz - 20 kHz
THD	< 1%
Sensitivity	105 dB
Charging Time	2 hours
Foldable	Yes
Water Resistance	No
Impedance	32 Ohm