Why does my THOR MS show a low DC input voltage?
If your THOR Inverter shows a low DC input voltage (below 10Vdc), it could be due to a few reasons. First, check if the battery voltage is too low and recharge the power source if needed. Another possible cause is inadequate power being delivered to the inverter or excessive voltage drop. To fix this, try using heavier gauge wire.
How to stop television interference when using a THOR MS Inverter?
To minimize television interference with your THOR Inverter: * Place the inverter as far as possible from the television, using an extension cable if necessary. * Readjust the orientation of the inverter, the antenna cables, and the TV power cord. * Ensure the antenna provides an adequate, snow-free signal and uses high-quality, shielded antenna cable. * Avoid operating high-power appliances or tools with the inverter while using the TV. * Ensure the inverter's case is properly grounded.
What to do if my THOR Inverter is over temperature?
If your THOR Inverter is overheating, allow it to cool down. Make sure there is adequate ventilation around the inverter.
Why does my THOR Inverter have a high DC input voltage?
If your THOR Inverter shows a high DC input voltage (above 16Vdc), the battery voltage is likely too high. Check for any faults with the battery charging system.
What to do if my THOR MS Inverter shows OVERLOAD SHUTDOWN?
The OVERLOAD SHUTDOWN error occurs when the power tool or appliance draws too much voltage and cannot be used with your inverter, or when inadequate power is delivered to the inverter, causing excessive voltage drop. To resolve this, use heavier gauge wire. Note that the power tool or appliance may not be compatible with your inverter.
What to do if my THOR Inverter displays GROUND FAULT PROTECTION / SHORT CIRCUIT PROTECTION?
If your THOR Inverter shows a GROUND FAULT PROTECTION or SHORT CIRCUIT PROTECTION error, it means the inverter senses a leakage current on the ground terminal or a short circuit current on the AC sockets. Unplug the AC appliance or power tool. Turn off the inverter, disconnect it from any 12 VDC power source, and then check the appliance or power tool and its cord.
How to fix television interference when using a THOR MS Inverter?
To minimize television interference when using a THOR Inverter: * Place the inverter as far as possible from the television, using an extension cable if needed. * Readjust the orientation of the inverter, antenna cables, and the TV power cord. * Ensure the antenna provides an adequate signal and uses high-quality, shielded antenna cable. * Avoid operating high-power appliances or tools while using the inverter with the TV. * Make sure the inverter’s case is properly grounded.
What to do if my THOR MS Inverter shows LOW DC INPUT VOLTAGE?
If your THOR Inverter displays a LOW DC INPUT VOLTAGE, it means the battery voltage is too low, or there is inadequate power being delivered to the inverter causing excessive voltage drop. Check or recharge the battery power source and use heavier gauge wire.
Why is my THOR Inverter making a buzzing sound in the audio system?
The buzzing sound occurs because the power supply in the electronic device does not adequately filter the modified sine wave produced by the THOR Inverter. The only solution to this problem is to use a higher quality sound system.
What to do if my THOR MS shows HIGH DC INPUT VOLTAGE?
If your THOR Inverter displays a HIGH DC INPUT VOLTAGE, it means the battery voltage is too high. Check for a fault with the battery charging system.
General| Output Waveform | Pure Sine Wave |
|---|---|
| Efficiency | >90% |
| Frequency | 50Hz / 60Hz |
| Input Voltage | 12V/24V/48V |
| Protection Features | Overload, Short Circuit |
| Cooling | Fan |
| Humidity | 5% to 95% (Non-condensing) |
| Series | MS Series |
To Next Page
