What to do if my THOR Inverter is over temperature?
If your THOR Inverter is overheating, let it cool down and ensure it has enough ventilation. Also, try decreasing the load to the inverter's continuous output rating. The inverter may enter thermal shutdown mode if it gets too hot.
Why does my THOR Inverter show overload shutdown?
If the overload shutdown occurs on your THOR Inverter, it means that a power tool or appliance is drawing too much voltage and cannot be used with your inverter, or inadequate power is being delivered to the inverter. Try using heavier gauge wire.
What to do if my THOR THPW-2000 Inverter shows ground fault protection or short circuit protection?
If your THOR Inverter indicates a ground fault or short circuit, unplug the appliance or power tool. Then, turn off the inverter and disconnect it from the 12VDC power source. Check the appliance, power tool, and cord for any issues. The inverter may sense a leakage current or short circuit.
How to reduce television interference from my THOR THPW-2000?
If you are experiencing television interference when using your THOR Inverter, try these steps: * Place the inverter as far away from the television as possible, using an extension cable if needed. * Readjust the orientation of the inverter, antenna cables, and the TV power cord. * Ensure the antenna provides a good signal and uses high-quality, shielded cable. * Avoid operating high-power appliances or tools while using the TV with the inverter. * Make sure the inverter case is properly grounded.
Why is my THOR THPW-2000 Inverter showing a low DC input voltage?
If your THOR Inverter displays a low DC input voltage (below 10Vdc), the battery voltage may be too low, or there may be inadequate power being delivered to the inverter. Check or recharge the battery and use heavier gauge wire.
What to do if my THOR THPW-2000 Inverter has no function and the digital display doesn't illuminate?
If your THOR Inverter's digital display does not illuminate, ensure that the inverter is properly connected to the power source (battery).
Why is my THOR THPW-2000 Inverter showing a high DC input voltage?
If your THOR Inverter shows a high DC input voltage (above 16Vdc), the battery voltage is too high. Check for a fault with the battery charging system.
Why does my THOR THPW-2000 cause a buzzing sound in audio systems?
If you hear a buzzing sound in your audio systems when using the THOR Inverter, the power supply in the electronic device might not adequately filter the pure sine wave produced by the inverter. The only solution to this problem is to use a higher quality sound system.
Essential pre-operation instructions to prevent injury or damage.
Defines hazard symbols (Danger, Warning, Caution) and provides general safety advice.
Critical warnings about electrical shock, fire risks, and safe handling practices.
Defines acceptable input voltage range and connection rules.
Explains error codes (E01-E05) and no-function scenarios.
General| Output Power | 2000W |
|---|---|
| Peak Power | 4000W |
| Input Voltage | 12V DC |
| Waveform | Pure Sine Wave |
| Model | THPW-2000 |
| Category | Inverter |
| Frequency | 60Hz |
| Efficiency | 90% |
| Protection | Overload, Short Circuit |
| Cooling | Fan Cooling |
To Next Page
