TROUBLESHOOTING GUIDE
Replacing the oven light
a. Make sure the oven and the bulb are cool.
b. Unplug the range or disconnect the power.
c. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
d. Turn the bulb counterclockwise to remove it from its socket.
e. Insert a new 40 watt appliance bulb,and then turn it clockwise
to tighten.Replace the bulb cover by turning clockwise.
f. Plug in the range or reconnect the power.
CAUTION
Before changing your oven light bulb,disconnect the
electrical power to the range at the main fuse or
circuit breaker panel.Make sure the oven and the bulb
are cool.
REPLACING THE BURNER PARTS
This diagram shows how to replace the burner parts. When replacing the burners, make sure that the
two locating pins on the bottom of the brass flame spreader are properly aligned with the locating pin
holes on the top of the simmer ring. Incorrect alignment will produce a potentially dangerous flame and
poor burner performance such as sparking/clicking.
25
To Next Page
Loading...
