Need help?Do you have a question about the THORENS TD 240-2 and is the answer not in the manual?
Set tracking force adjuster to 0 and anti-skating knob counter-clockwise.
Screw counterweight onto arm tube and balance the tone arm.
Adjust tracking force and anti-skating force for optimal playback.
Adjust cartridge for precise stylus overhang using a gauge.
Remove signal leads, unscrew cartridge, attach new cartridge, and connect leads.
Adjust cartridge alignment using a mounting gauge for correct stylus overhang.
Adjust the screw to ensure the needle accurately lands in the starter groove.
Set tracking force adjuster to 0 and anti-skating knob counter-clockwise.
Screw counterweight onto arm tube and balance the tone arm.
Adjust tracking force and anti-skating force for optimal playback.
Adjust cartridge for precise stylus overhang using a gauge.
Remove signal leads, unscrew cartridge, attach new cartridge, and connect leads.
Adjust cartridge alignment using a mounting gauge for correct stylus overhang.
Adjust the screw to ensure the needle accurately lands in the starter groove.
General| Type | Belt-drive audio turntable |
|---|---|
| Nominal speeds | 33 1/3, 45, 78 RPM |
| Output voltage | 3.5 mV |
| Housing material | Wood |
| Platter material | Metal |
| Signal-to-Noise Ratio (SNR) | 72 dB |
| Frequency range | 20 - 20000 Hz |
| USB ports quantity | - |
| AC adapter frequency | 50-60 Hz |
| AC adapter input voltage | 100 - 240 V |
Weight and Dimensions| Weight | 8500 g |
|---|---|
| Platter weight | 700 g |
| Platter diameter | 305 mm |
| Product dimensions (WxHxD) | 440 x 125 x 360 mm |
To Next Page
