Need help?Do you have a question about the THORENS TD 280 Mk IV and is the answer not in the manual?
Maintenance of the platter and motor bearing, including greasing procedures.
Procedure for removing and installing the tonearm assembly.
Adjusting the tonearm lift height for proper record clearance.
Explanation of the turntable's synchronous motor drive circuitry.
Details on the automatic shut-off function at the end of a record.
Procedure for setting turntable speeds using potentiometers P1 and P2.
Maintenance of the platter and motor bearing, including greasing procedures.
Procedure for removing and installing the tonearm assembly.
Adjusting the tonearm lift height for proper record clearance.
Explanation of the turntable's synchronous motor drive circuitry.
Details on the automatic shut-off function at the end of a record.
Procedure for setting turntable speeds using potentiometers P1 and P2.
General| Drive system | Belt drive |
|---|---|
| Motor | Low-noise DC motor |
| Platter | Aluminum die-cast |
| Tonearm | TP 28 |
| Anti-skating | Adjustable |
| Cartridge | Not included (compatible with MM/MC) |
| Dimensions | 420 x 355 x 125 mm |
| Weight | 5.8 kg |
| Type | Manual |
| Drive Method | Belt-drive |
| Speed | 33 1/3, 45 RPM |
| Speeds | 33 1/3, 45 RPM |
| Output level | Depends on cartridge |
| Signal-to-noise ratio | > 70 dB |
| Channel balance | 2 dB |
To Next Page
