Page 6 20381-D02
Single- and Dual-Axis Scanning Galvo Systems for Large Beam Diameters
Caution
When connecting the driver boards and motors use only the cables supplied.
Do not extend the cables. The driver boards and motors are calibrated with
these cables. Using different cables will affect the performance of the system.
Caution
The driver circuit board is shipped calibrated and ready for use. The only
adjustments necessary are setting the Volts/Degree Scaling factor (see Section
3.2.5. and if required, setting the device for external enabling see Section 4.2.
Do not attempt to make any other adjustments or remove/fit any other jumpers
than those explicitly described in the following sections as this could invalidate
the warranty.
To Next Page
Loading...
Need help?
General
