© 2012 Thorlabs
5 Appendix
17
5.2 Certifications and Compliances
EC Declaration of
Conformity - EMC
Meets intent of Directive 2004/108/EC
1
for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
Electrical equipment for measurement, control and laboratory use –
EMC requirements:
Immunity: complies with basic immunity test requirements
2
.
Emission: complies with EN 55011 Class B Limits
2,4
,
IEC 610003-2 and IEC 61000-3-3.
Electrostatic Discharge Immunity (Performance Criterion B)
Radiated RF Electromagnetic Field Immunity (Performance Criterion
A)
Electrical Fast Transient / Burst Immunity (Performance Criterion B)
Conducted RF Immunity (Performance Criterion A)
Emissions comply with the Class B Limits of FCC Code of Federal Regulations 47, Part 15,
Subpart B
2,4
.
EC Declaration of
Conformity - Low
Voltage
Compliance was demonstrated to the following specification as listed in the Official Journal
of the European Communities:
Low Voltage Directive 2006/95/EC
7
Safety Requirements for Electrical Equipment for Measurement,
Control and Laboratory Use - Part 1: General Requirements
U.S. Nationally
Recognized Testing
Laboratory Listing
CAN/CSA C22.2 No.
61010-1 2
nd
ed.
Class I equipment (as defined in IEC 60950-1:2001)
1
Replaces 89/336/EEC.
2
Compliance demonstrated using high-quality shielded interface cables shorter than or equal to 3 meters.
4
Emissions, which exceed the levels required by these standards, may occur when this equipment is connected to a test object.
7
Replaces 73/23/EEC, amended by 93/68/EEC