How to fix Thrane&Thrane Marine Equipment that cannot be switched on?
If your Thrane&Thrane Marine Equipment system isn't turning on, and you're using a remote on/off switch, try using that switch instead of the power button. Also, verify that all power cables connecting the ship's power source to the SAILOR 6006 are properly connected and that the power source is active.
What to do if there is no signal from the satellite on Thrane&Thrane Marine Equipment?
To address a weak or absent signal from the satellite on your Thrane&Thrane Marine Equipment, ensure the SAILOR 3027 has an unobstructed view in all directions. Refer to the installation manual for specifics. If the system is configured for a specific satellite, ensure that you are within that satellite's coverage area by logging into a satellite that covers your current location.
What to do if Thrane&Thrane Marine Equipment Message Terminal cannot switch off?
If your Thrane&Thrane Marine Equipment Message Terminal won't switch off, try pressing and holding the Power button for 10 seconds. This action is suggested to resolve the software error.
How to troubleshoot no connection between SAILOR 6006 and SAILOR 3027 on Thrane&Thrane Marine Equipment?
If there's no connection between the SAILOR 6006 and SAILOR 3027 in your Thrane&Thrane Marine Equipment, ensure the CAN cables are correctly connected and undamaged.
Why is there no battery information in the SAILOR 6006 of my Thrane&Thrane Marine Equipment?
If the SAILOR 6006 in your Thrane&Thrane Marine Equipment displays no battery information, check the Link activity indicator at the connection points in the Ethernet switch. Ensure that the Ethernet cables are properly connected and are not damaged.
What to do if Thrane&Thrane Marine Equipment shows “out of paper” although there is paper in the printer?
If your Thrane&Thrane Marine Equipment shows an 'out of paper' message even when the printer has paper, adjust the paper to the left side of the printer.
How to fix no connection between SAILOR 6006 and printer on Thrane&Thrane Marine Equipment?
If there is no connection between SAILOR 6006 and the printer in your Thrane&Thrane Marine Equipment, check that the USB cable is correctly connected and is not damaged.
Introduction to the SAILOR 6110 system and its capabilities.
Explanation of the GMDSS and Inmarsat C satellite network.
Description of the basic SAILOR 6110 system components.
Overview of the main user interface in the SAILOR 6006.
Process of registering the SAILOR 3027 GMDSS Terminal.
Steps to power on and log into the SAILOR 6110 system.
Procedure for sending a Distress Alert using the system.
Instructions for writing, sending, and managing messages.
How to view incoming Enhanced Group Calls (EGCs).
How to check and understand the system's network status.
Viewing current position, course, and speed information.
How to perform a test on the system's Distress buttons.
How to obtain assistance from airtime providers or distributors.
Steps to create a diagnostic report for troubleshooting.
Table of common problems, causes, and remedies.
Understanding system status and error messages.
General| Vibration | IEC 60945 |
|---|---|
| Operating Temperature | -25°C to +55°C |
| Impedance | 50 Ohms |
| Humidity | 95% non-condensing |
| VSWR | 1.5:1 max |
| Storage Temperature | -40°C to +70°C |
To Next Page
