step 14: install the tipping restraint hardware kit
14.1. Follow the instructions printed on plastic bag containing tipping restraint hardware to attach tip-over restraint between the unit and wall.
NOTE: You can share the back panel screw hole for the anti-tipping hardware. You must use this tipping restraint to attach this unit to the wall, to prevent
accidents and/or injures.
Tools required: Phillips screwdriver, stud finder, tape measure, pencil, power drill and 1/8” drill bit (not provided).
Wooden stud
(H19) x 2
tipping restraint hardware kit
Wall
Metal bracket Nylon strap
Short screw
Wall
Long screw
H19
20
To Next Page
Loading...
