CONNECTING THE RACING WHEEL TO THE MAINS
European versions only
Important note: the European version of the T100 FFB is equipped with an internal power supply, located
directly inside the racing wheel's base.
The European version must exclusively be supplied with 220V!
Never open the racing wheel base – shock hazard!
- Simply connect the racing wheel's mains connector to a 220 V power outlet.
Other versions (non-European)
Note: Contrary to the European version, the non-European T100 FFB features an external power supply;
a specific device is provided with the racing wheel.
- Connect the external adapter to the relevant connector located at the back of the racing wheel, then
connect the external mains power adapter to a standard power outlet featuring the same voltage.
CONNECTING THE PEDAL SET TO THE RACING WHEEL
Connect the pedal set to the racing wheel using the relevant connector, located at the back of the racing
wheel.
AUTOMATIC RACING WHEEL AND PEDAL SET CALIBRATION
The racing wheel calibration occurs automatically when you connect the racing wheel's power adapter and
USB connector. (This operation causes the racing wheel to move.) The pedal set calibration also occurs
automatically; simply press the pedals a few times.
- Never connect the racing wheel's USB connector before connecting the pedal set
- Never press the pedals when the racing wheel starts
(when the racing wheel self-calibrates following connection, or when starting or exiting a
and in the Control Panel interface on PC,
the racing wheel is recognized as an F430 Force Feedback racing wheel,
which offers the same features as this one
To Next Page
Loading...
Need help?
General
