Attaching the steering wheel and pedal set to a cockpit
1. Place the steering wheel on the Cockpit’s tablet.
2. Tighten 2 “M6” screws (not supplied) into the Cockpit table and into the 2 small screw threads
under the wheel.
Important note for the Wheel
3. If necessary, screw in the standard clamping system (into the large screw thread).
: These screws must not be longer than 12mm to avoid damaging
the components inside the base.
4. In the same way, attach the Pedal set using the small screw threads underneath it.
Note for the Pedal set
Do not hesitate to test the different possible settings for more comfort.
: In certain cockpits the “Floor position” (F1 type) will be more user-friendly.
On others the “Suspended position (GT/Rally type)" will be more comfortable.
To Next Page
Loading...
