9/20
INSTALLATION ON PLAYSTATION®3
1. Connect the pedal set to the steering wheel by plugging in its connector (11) at the back of the
wheel.
2. Connect the mains adaptor to the wheel (13) by plugging in its connector to the back of the wheel.
3. Connect the mains adaptor to its power cable (14).
Note: To be sure that the 2 elements are perfectly connected, push the power cable’s connector into
the mains adaptor socket firmly.
4. Connect the mains cable (14) to a socket.
5. Connect the wheel’s USB connector (12) to the console’s No. 1 port.
You are now ready to play!
AUTOMATIC CALIBRATION FOR THE WHEEL AND PEDALS
The wheel calibrates itself automatically once the mains adaptor and the USB connector are connected.
This operation will cause the steering wheel to move quickly 1080° to the left and right before coming
to its final position in the center.
When calibrating the steering wheel
CAUTION:
never touch the wheel
(this may mislead the calibration or cause injury).
The pedals are also calibrated automatically once they have been pressed a few times.
TROUBLESHOOTING & TIPS
- My wheel and my pedals don’t work correctly or appear to be improperly calibrated:
Switch off your console, completely disconnect your wheel including all cables (with the mains
adaptor and the pedal set) and restart your game.
- There are various tips and help features (not included in this manual) available on the
website
http://ts.thrustmaster.com in the Technical Support category.
To Next Page
Loading...
Need help?
General
