To Next PageTo Next Page
Need help?Do you have a question about the Thule TracRac TracOne and is the answer not in the manual?
General| Brand | Thule |
|---|---|
| Model | TracRac TracOne |
| Category | Automobile Accessories |
| Language | English |
Tools needed for fastener adjustment, measurement, and proper tightening.
Tool for ensuring fasteners are tightened to the correct specification for safety.
Tools to facilitate easier attachment of hexagonal fasteners and socket use.
Power tool option for faster and more efficient installation process.
Important precautions on load capacity, vehicle compatibility, and safe transport practices.
Connecting the upright to the saddle, ensuring correct orientation for fit.
Fastening the saddle to the upright using specific screws and recommended torque.
Attaching the assembled upright and saddle to the base component.
Instructions to replicate the upright assembly steps for all remaining units.
Gathering and pre-threading screws, nuts, and uprights for crossbar connection.
Connecting the crossbar to the uprights using the saddle and provided fasteners.
Initial assembly of load stop components and loosely attaching the knob.
Sliding tiedowns into crossbar and installing endcaps, securing with fasteners.
Placing shims and attaching front/rear uprights onto the truck's sidewalls.
Fine-tuning upright placement for optimal contact with the truck bed L-rail.
Inserting screws into clamps and positioning the clamp feet.
Ensuring proper tension with clamp feet to prevent damage to the rack and truck bed.
Placing the front base and connecting clamp assemblies to the truck bed.
Securing clamps with torque and repeating the process for the rear section.
Aligning crossbars centrally and fastening them with specific bolts and torque.
Key recommendations for safe product use, maintenance, and legal compliance.
Details on warranty coverage, product exclusions, and consumer legal rights.
