THUNDER TIGER EB 4 RALLY CAR - User Manual

1/8 4WD RALLY CAR
Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship.
The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty
does not cover any components damaged by use or modification. Part or parts missing from this kit must be
reported within 60 days of purchase. No part or parts will be sent under warranty without proof of purchase.
To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective
part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor
nearest you. Under no circumstances can a dealer or distributor accept return of a kit if assembly has started.
WARRANTY
INSTRUCTION MANUAL
No.6224-F

THUNDER TIGER EB 4 RALLY CAR Specifications

General

Drive Type	4WD
Radio System	2.4GHz
Type	Rally Car
Engine Type	Nitro
Tire Type	Rally

Summary

WARRANTY

INTRODUCTION AND REQUIRED ITEMS

ITEMS REQUIRED FOR OPERATION

Lists essential items needed before operating the RC car.

TOOLS INCLUDED

Details the tools provided with the Thunder Tiger RC car model.

INITIAL ASSEMBLY AND SETUP

UNPACKING AND PREPARATION

Instructions on unpacking the kit, charging the glow plug igniter, and removing wheels.

TIRE AND RADIO SETUP

Guides on gluing tires, preparing the radio system, and installing batteries.

RADIO CONTROL OPERATION

RADIO SYSTEM POWER-UP

Proper procedure for turning the RC car's radio transmitter and receiver on/off.

STEERING AND THROTTLE;BRAKE CHECKS

Verifies and adjusts steering, throttle, and brake servo functions.

ENGINE TUNING AND OPERATION

THROTTLE;BRAKE LINKAGE ADJUSTMENT

How to properly adjust the throttle and brake linkage on the RC car.

CARBURETOR SETTINGS

Guide to setting the engine's carburetor idle, high-speed, and low-speed needles.

FUELING THE ENGINE

Instructions on how to fill the fuel bottle and the car's fuel tank with glow fuel.

ENGINE STARTING AND BREAK-IN

Procedures for starting, breaking in, and setting the engine for optimal performance.

CHASSIS AND SUSPENSION SETUP

SHOCK AND REAR TOE-IN ADJUSTMENT

Adjusts shock pre-load for ride height and rear toe-in for handling.

FRONT AND REAR SUSPENSION SETTINGS

Details front/rear camber, caster, toe, wheelbase, and ride height adjustments.

CENTER DIFFERENTIAL SETUP

Covers center differential brake bias and gear settings.

SAFETY AND TROUBLESHOOTING

GENERAL SAFETY WARNINGS

Important safety precautions and warnings for operating the RC product.

GLOW PLUG AND ENGINE ISSUES

Diagnosing and resolving problems with the glow plug, engine flooding, and fuel mixture.

FACTORY CARBURETOR SETTINGS

Default factory settings for carburetor idle, low speed, and high speed needles.