hold pushrod tubes in place.
III. Motor Installation
A. File the motor mount at the beam as shown for better fitness.
4
FUSELAGE
II. Pushrod Housing Installation
A. Carefully install rudder and elevator pushrod tubes;insert the ele-
vator pushrod tube through the hole in the rear former through the
fuselage and out the pre-drilled hole in the right of the rear cabin for-
mer.
B. With a hobby knife,remove covering from existing slot in top rear
of fuselage and insert rudder pushrod tube through fuselage and out
pre-drilled hole in left rear cabin former. Use just a dab of CA glue to
R
L
To Next Page
Loading...
Need help?
General
