To Next PageTo Next Page
Need help?Do you have a question about the THUNDER TIGER mini Titan V2 and is the answer not in the manual?
General| Type | Helicopter |
|---|---|
| Model | Mini Titan V2 |
| Brand | Thunder Tiger |
| Engine Type | Electric |
| Motor | Brushless |
| Radio | Not included |
| Skill Level | Intermediate |
| Battery | LiPo |
Disconnect wires and unscrew tail unit from main frame.
Steps to remove the motor unit from the helicopter.
Instructions to detach the main gear and rotor head assembly.
Assemble the left main frame as shown in the drawing.
Assemble tail drive gear set and secure to main frame.
Assemble battery tray, anti-rotation bracket, bottom bracket, and canopy standoff.
Assemble landing skid, canopy clip, and antenna holder.
Install main gear set and main shaft into the frame and housings.
Instructions to loosen screws for later belt adjustment.
Insert tail unit, twist belt, and attach tail bracket to main frame.
Adjust belt tension and secure tail bracket on tail boom.
Mount motor to mount and secure drive gear to motor shaft.
Install motor mount and adjust gear mesh for backlash.
Attach linkage balls to servo arms and secure servos to frame.
Attach receiver and gyro to main frame using double-sided tape.
Mount ESC and battery using Velcro straps.
Wedge canopy into clip and attach to main frames using grommets.
