THUNDER TIGER mini Titan V2 User Manual

m Electric System-1 ####-1
No. [ пет No. — | Description 28 0] Step 1 / 20:—
*1 [BKi880 | Motor Mount ЕТТ 1 | 1. Mount the motor to the Motor Mount.
#2 [HSAS5B | Socket Screw M3X5 жайлай MAKA 2 | 2. Secure the Drive Gear to the motor shaft tightly with a
жэ [HSA26 | Button Head Socket Screw, | ЖЕЙЛИ | 4 | drop of threadlocking.
М6. MONG 1. ЖШШЕ ЕЛА RS ЕЕ Hs E °
4 [HMES3B ` | Set Screw M3 ATARA МЭХЗ 1] 2. (ааа неа дарае EEE -
P Step 2 / RZ
1. Install the Motor Mount into the main frame.
2. Adjust the mesh between the Main Gear and Drive Gear
. until there is a small amount of backlash all the way.
SS q 1. ЖИН ОТЕ FP IEE LES <
#262, 2. WIRE RAI 2 b ^ MERESUE IEEE -
(
4
==
@ 1
The length from the епа of Drive Gear
to Motor Mount is 16mm.
Ash GA RC is RB БАЕ 6MM •
=
You can observe the gear mesh from
the bottom of Bottom Bracket. Apply threadlocker
EXT te HERB IE apus ERR FUR. - ЕНИКИ
m
Electric
System-2
2717-2
Apply
threadlocker
ФЕН
No. | item No. — [ Description. Er]
#1 [HMC288 [Socket Screw WASIMA N2X8
Must be purchased separately
ЕЕ]
T
1. Remove the servo wheel prior to attaching the Linkage Ball.
2. Mount the Linkage Ball at 12.5mm from the center of the servo arm.
3. Secure the servo to the right Servo Tray and attach the rod to the servo arm.
1. ЖЕНЫ} LWIR MANE Н ЕК, ERR •
2. FE GR ЗО ЕТЕДГ ТУП Ш12.5тгп® °
3. ЕНЕНЕ A SER (SUR HM SED ГАН НИГЫ ДЕ НЕ ЯН RI аа н < САС ИЯНЕ MANE ВЗ IAS GR)
We

THUNDER TIGER mini Titan V2 Specifications

General

Brand	THUNDER TIGER
Model	mini Titan V2
Category	Toy
Language	English