ㅣ
1918
ㅣ
6.4. Receiving fax messages with a PC/Laptop
1. Dock your Thuraya handset into the FDU-XT.
2. Connect the PC to the USB or DTE serial interface of the FDU-XT.
3. Switch on the FDU-XT.
4. Activate the fax software on the PC/Laptop.
5. If there is no Group3 fax machine connected to the FDU-XT, all incoming fax
messages will be received by the connected PC/Laptop.
While sending a fax through PC connected at the USB or DTE interface, the fax software
should be configured in the class 2.0 mode. When sending a fax through Quick Link or Hot
Fax, select “Thuraya Mobile Phone” or “Standard 19200 Modem” as a modem.
Note
7.1. Sending data from a PC/Laptop
1. Dock your Thuraya handset into the FDU-XT.
2. Connect the PC to the USB or DTE serial interface of the FDU-XT.
3. Switch on the FDU-XT.
4. Start the data communication software of your PC.
5. Enter the destination number.
6. Select the data file to be sent.
8. Use the respective start function of the data communication software to start
transmitting the file.
7.2. Receiving data
1. Dock your Thuraya handset into the FDU-XT.
2. Connect the PC to the USB or DTE serial interface of the FDU-XT.
3. Switch on the FDU-XT.
4. Start the data communication software on the PC/Laptop.
5. You will hear a special signal on the docked Thuraya handset when a data
call is arriving.
7. Receiving/Sending Data
You can use your FDU-XT to receive and make data calls through a PC connected
at the USB or DTE interface. To receive/make data calls by a PC, appropriate data
communication software needs to be installed on the PC.
The baud rate of the PC data communication software should be set at 19200bps.
Note
8. GmPRS Connection
With your FDU-XT you can access Thuraya’s GmPRS network. Use the USB or
serial DTE port to connect the FDU-XT to your PC or laptop.
Setting a phone connection modem to access Thuraya’s GmPRS network
1. Select “Control Panel Phone and Modem Option Modems” and then set
a port by adding the “Standard 33600bps Modem” according to the
following procedures.
6.3. Sending fax messages with a PC/Laptop
1. Dock your Thuraya handset into the FDU-XT.
2. Connect the PC to the USB or DTE serial interface of the FDU-XT.
3. Switch on the FDU-XT.
4. Start the PC fax software
5. While configuring the fax software, select 'fine' as resolution.
6. Enter the destination number.
7. Select the document to be sent.
8. Use the respective start function of the fax software to start transmitting the fax.
To Next Page
Loading...