37
vd84-201113
Without further keystroke, the unit switches to Auto-Off Mode after approx. 5 sec-
onds. The last settings are saved.
5.4 Maximum Operation Time
When operating continuously in Cont Mode or Data Logger Mode the unit stays
switched-on, until a selected maximum operation time has elapsed. To set this
maximum operation time, after which the unit is automatically turned-off anyway,
switch the VD84 into Configuration Mode. Therefore the instrument must be
switched-off. Hold the Mode-Key pressed then, until the display shows "rAtE".
Then press Mode-Key several times, until the display shows "hour":
After 5 more seconds the current setting of maximum operation time is displayed:
Using the Mode-Key you can now select a
timespan from 1h to 24h or cont (no switch-off).
Without further keystroke, the unit switches to Auto-Off Mode after approx. 5 sec-
onds. The last settings are saved.
To Next Page
Loading...
