Need help?Do you have a question about the Thyracont VD85 and is the answer not in the manual?
General| Accuracy | +/- 15% of reading in the range of 1 x 10^-3 to 100 mbar |
|---|---|
| Sensor type | Pirani |
| Operating temperature | +5 to +50 °C |
| Power supply | 24 V DC, 0.5 A |
| Display | LCD |
| Weight | 0.5 kg |
| Gas type dependence | Yes |
| Output signal | 0-10 V DC |
| Process connection | DN 16 ISO-KF |
| Output | 0-10 V DC |
| Storage Temperature | -20 to 70 °C |
Defines the intended use of the VD84 for total pressure measurements in gaseous media.
Explains how to connect the vacuum sensor to the flange and grounding requirements.
Explains how to insert the battery and details battery types and low power indication.
Details the USB interface, its pinout, and its use with VacuGraph software.
Explains the two modes for displaying pressure: Short-Term (Auto-Off) and Continuous Operation.
Describes how to operate the VD84 in pressure display mode with data logging enabled.
Explains how to enter Data Logger Mode and how measurements are stored.
Explains how to set the logging rate for internal data logging and the available options.
To Next Page
