Thytronic NA60-MB0 PRON Series - 6 Appendix A. Address Data Table

PRON NA60-MB0
Version 3.50
PRON NA60-MB0 Remote Setting Manual Page: 18 of 59
6 Appendix A. Address Data Table
VAR REF IDX DIM TYPE Range Um Kv ENUM
Commands
Set RTC 0x 1 1 CMD 0=OFF, 1=ON
Reset CB Open counter 0x 2 1 CMD 0=OFF, 1=ON
Reset LEDs 0x 3 1 CMD 0=OFF, 1=ON
Reset CB time action 0x 4 1 CMD 0=OFF, 1=ON
Reset MTV 0x 5 1 CMD 0=OFF, 1=ON
Reset Breaking currents SumI2t 0x 6 1 CMD 0=OFF, 1=ON
Reset Breaking currents SumI 0x 7 1 CMD 0=OFF, 1=ON
Reset partial counters 0x 8 1 CMD 0=OFF, 1=ON
Thermal image presetting 0x 9 1 CMD 0=OFF, 1=ON
Fault reading 0x 10 1 CMD 0=OFF, 1=ON
Reset faults 0x 11 1 CMD 0=OFF, 1=ON
Reset faults identifier 0x 12 1 CMD 0=OFF, 1=ON
Events reading 0x 13 1 CMD 0=OFF, 1=ON
Reset events 0x 14 1 CMD 0=OFF, 1=ON
Reset event identifier 0x 15 1 CMD 0=OFF, 1=ON
Open CB 0x 16 1 CMD 0=OFF, 1=ON
Close CB 0x 17 1 CMD 0=OFF, 1=ON
Test-off 0x 18 1 CMD 0=OFF, 1=ON
Test-on 0x 19 1 CMD 0=OFF, 1=ON
Reset on demand measures 0x 20 1 CMD 0=OFF, 1=ON
Reset on energy measures 0x 21 1 CMD 0=OFF, 1=ON
PLC2 Command - 1 0x 22 1 CMD 0=OFF, 1=ON
PLC2 Command - 2 0x 23 1 CMD 0=OFF, 1=ON