Thytronic NG10 - Residual Overcurrent;High Impedance Ground Fault: Blocking Logic Continued

FUNCTION CHARACTERISTICS
48
NG10 - Manual - 04 - 2022
ment (Start IE>, Start IE>> e/o Start IE>>>) becomes active. The enable (ON or OFF) by means
of the IE>BLK2OUT,IE>>BLK2OUT and/or IE>>>BLK2OUT parameters, inside the Set \
Profile A(or B) \ 50N/51N-87NHIZ \ IE> Element (IE>> Element, IE>>> Element) \ Setpoints menus,
while the BLK2OUT-Iph-K,BLK2OUT-Iph/IE-K(relays) and/or BLK2OUT-IE-K) and (BLK-
2OUT-Iph-L,BLK2OUT-Iph/IE-Land/or BLK2OUT-IE-L) (LEDs) must be select inside the Set
\ Profile A(or B \ Selective block-BLOCK2 \ Selective block OUT menu.