Tiandy IP Speed Dome Camera - Page 73

MOTION
-------------------------------------------
<Preset>
<Scan>
<Cruise>
<Pattern>
<Zones>
<Timing Action>
Back
Exit
PRESET
-------------------------------------------
Preset Number ：001
Title Set ：PRESET01
Call
<Set>
Delete
Back
Exit
A1
B1
C1
D1
E1
A1. Preset number
Move the cursor to "preset", press the stop on entering setup mode, preset, rocker,
preset up and down Settings. Ball machine supports a total of 220 preset positions,
1-64%.
B1. Title set
Move the cursor to "headers", press the stop on entering the preset position settings
submenu, preset bit set.Note: the current title set is on the WEB.
C1. call
Move the cursor to "call", press the stop on call corresponds to a set of presets.
D1. Set the aperture opened enter preset position setting mode, appears on the screen
"press IRIS open to confirm ...".Users can operate on the dome, reaches the desired
position and press the aperture set to store the current position.
E1. Deleted
Move the cursor to "delete", press the aperture on correspond to the preset preset
number.
B: Automatic scanning