Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may
cause undesired operation of the device.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure require-
ment. The device can be used in portable exposure condition without
restriction.
FCC ID:2AXUI-E200
Warning
MANUAL NEO14_EN_FR_NL_DE.indd 70 11/03/2020 16:00:56
.
CONTACT INFORMATION
alllinkluck@outlook.com
www.tibutapad.com
Designed by Tibuta,Assembled in PRC
UK AR
Company: UK CROSSBORDER LIMITED
Address: 7 Bell Yard London WC2A 2JR,UK
Mail: uk-crossborder@outlook.com
22-EN
To Next Page
Loading...