Cheetah Maintenance Section 4-12
MAINTENANCE
TIGHTENING SPINDLE BOLTS
The spindle mounting bolts should be checked and retorqued daily or every 8 hours of
service as follows:
Torque the (6) bolts shown below to 357 ft. lbs. dry or 315 ft. lb. lubricated (loctite 271)
MAINTENANCE
TIGHTENING KNIFE BOLTS AND DISK BOLTS:
After every 8 hours of operation or daily, the Knife Bolts and Disk Bolts should be tightened
as follows:
Knife mounting bolts (2ea) torque to 800 ft. lbs. lubricated
Disk mounting bolts (6ea) torque to 204 ft. lbs dry or to 184 ft. lbs. lubricayed (loctite 271)
To Next Page
Loading...