Cheetah Maintenance Section 4-19
MAINTENANCE
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours
of service, following the detailed maintenance instructions in the operators
manual.
______ Pump Drive Shaft: Check for end play in drive shaft / coupler and lubricate zerk
on coupler.
______ Crankshaft adapter: If equipped with rubber grommets check condition, replace
if missing or damaged.
______ Pivot points: Inject grease until it appears at ends.
______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten fittings or
replace hoses immediately.
______ Knives: Inspect for missing or damaged knives, change (only complete sets) as
needed.
______ Blade Bolts(1 1/8”): Check/Torque to 800 oiled ft lb. lubricated
______ Check / Tourque Disk Bolts 204 ft. lbs. dry and Spindle bolts 357 ft. lbs. dry.
______ Belts: Check / Tighten / Replace belts as needed.
______ Main Frame / Deck: Unless otherwise specified retorque bolts according to
torque specifications in this section.
______ Hydraulic Fluid Level: Add, if required, per fluid recommendations.
______ Rear Flail Drive, Bearing Flange and Shaft Couplers: Grease as instructed in the
detailed (if applicable) maintenance section.
______ Cutter Shaft and Ground Roller: Grease as instructed in the detailed
maintenance section.
Service performed by:_______ Date:____/____/____ Hour Meter:__________
Maintenance Section
** This page may be copied and used as part of the daily maintenance routine.
To Next Page
Loading...